Need PC COMMAND V2 Protocol Details

Forum dedicated to discussion on Icom Amateur Radio products
Post Reply
p.tyers@bigpond.com
Posts: 1
Joined: Tue Dec 10, 2019 2:05 am

Need PC COMMAND V2 Protocol Details

Post by p.tyers@bigpond.com » Tue Dec 10, 2019 2:30 am

Can anyone provide me with details of the ICOM PC COMMAND V2 protocol which unfortunately is not CI-V as I was led to believe

It appears to produce strings like
<STX>*GET,MCH,SEL<ETX> hex 02 2A 47 45 54 2C 4D 43 48 2C 53 45 4C 03
and
<STX>*SET,UI,PTT,ON<ETX>
and
<STX>*SET,UI,PTT,OFF<ETX>

sentences always start with <STX>* hex 02 2A and end with <ETX> hex 03

but I need an expanded set of commands and responses.

Project is to interface an OMNITRONICS IPR400 VOIP modem to an ICOM IC-801E marine set. The OMNITRONICS produces the PC COMMAND V2 stream and I will be using a Raspberry Pi (or similiar) to convert that to NMEA compatible sentences to control the Icom 801E.

Any pointers appreciated

Peter Tyers
VK3KTS

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests